Lucid Motors Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
361 Posts
Discussion Starter · #1 · (Edited)
If you have issues with camera views or other minor issues, you need to Soft Reset to make the functions work.

1. Use your Key Card to open the drivers door. Just hold the card above the camera on the middle post between both left doors to open.

2. Sit in the seat, turn one of the turn signals. Lr ot Rt, doesnt matter. Let it keep blinking and beeping.

3. Come out and close the drivers door and lock it with Key Card
same way placing above the camera to lock it.

4. Wait for few minutes after closing to the car, till the turn signal stops blinking.

Then all the camera functions are restored.

I had to do that today to restore my camera functions, which were frozen and none were working on the screen.


Good Luck.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top